Scythe Peening Jig – Blade work hardening angle guide – Muller Made In Austria


SKU: 4517 Category:


Made In Austria

  • Drill a hole and simply hammer the anvil and shaft into the hole until it is steady for mounting
  • 2 sleeves the red sleeve for sharpening and the yellow sleeve for peening
  • Each sleeve has a different angle on the bottom where it touches the base of the anvil and shaft to sharpen or peen you put the blade against the shaft and slide the sleeve over the shaft, hammer on the sleeve and it pinches the blade between the sleeve and anvil, slowly move the blade along as you hammer, make sure and keep the blade flat. Finish with a Scythe stone.
  • Mueller Axes, have been hand forged out of the Finest Austrian steel, dating all the way back to the 1600’s
Print Friendly, PDF & Email